Melodic Folds中文

★★☆☆☆ Starter folds · 7 steps

Flat Heart from a 1:2 Rectangle

Published · By The Origami Desk

Most folded hearts come out with a pointy top and no lobes. The fix is a rectangle, and two reverse folds that pull the top corners outward instead of inward.

Flat Heart from a 1:2 Rectangle finished crease pattern

finished crease pattern

Fold sequence

1 / 7
Flat Heart from a 1:2 Rectangle crease pattern at step 1
Frame 01 / 7

Step 1

Cut or fold a 15 x 7.5 cm rectangle. Place it coloured side up in portrait.

Next crease → 02

Show the whole sequence on one page

Why 1:2 and not a square

A square heart has to borrow height from the lobes, so the top comes out narrow. A 1:2 rectangle gives 7.5 cm of spare length on a 15 cm strip, and that is exactly what the two rounded lobes need. The finished heart is 9.8 cm wide and 8.4 cm tall.

The two reverse folds

Steps 5 and 6 are outward reverse folds at the top corners. Each one turns a flat corner into a rounded lobe by reversing the fold direction at the corner's midpoint. The two must be reversed at the same distance from the outer edge; on a 15 cm strip that is 2.6 cm.

Getting a heart that lies flat

The heart will bow if the centre line is over-creased while the lobes are under-creased. Crease the central spine once, firmly, and then crease each lobe twice with a lighter thumb pressure. Placed under a book for ten minutes, a paper heart stays flat enough to glue onto a card.

Paper specification

Sheet size15 cm
Sheet ratio1:2
Paper weight80 gsm
steps7
Difficulty★★☆☆☆
Basedouble-kite

A 1:2 rectangle (15 x 7.5 cm) rather than a square. The heart needs the extra length for the two lobes.

Crease symbol quick reference

Crease notation usedcountfirst move
Mountain fold2Locate the line on the diagram; confirm the direction by looking at the adjacent valley folds.
Valley fold4Bring the edge or corner exactly to its target point and hold it there.
Reverse fold2Open the point along its existing crease, all the way to the base.

Crease symbol glossary

What goes wrong

The top is pointy, not lobed

The reverse folds in steps 5 and 6 were made inward. They must swing the corners away from the centre line.

The heart curls up

The lobes were creased harder than the spine. Flatten under a book for ten minutes.

Making it hold

  • Measure both reverse folds from the outer edge, not from the centre.
  • Round the lobes with a thumb, pressing from the outside inward.
  • Crease the spine once and the lobes twice, lightly.